Go-Blog! Comments, tips & reviews.

Go-Pod Dimensions

Posted on

0 Comments

Measurements for your Go-Pod follow - please review the important footnotes.

2018 Models with 1000Kg max load.

External Dimensions:

Length - 4.20m including 0.99m hitch & bar.
Width - 1.85m
Height - 2.05m roof down. Raising pop top adds 30cm.
*Note regarding garage storage  Recommended minimum clearance - 210cm.
MiRO - 490Kg (Actual Mass = 575Kg) Based on Standard model.
Brakes - AL-KO Braking System.
MTPLM - 1000Kg
Nose Weight - 49Kg (54Kg with front box & gas bottle plumbed) 
Ground Clearance. - 183mm NB: Lowest point is the removable spare wheel.
     

Internal Dimensions:

Standing height - 1.84m
Floor - full length - 2.05m
Floor - width - 0.62m
Floor - bed end of aisle to door   - 1.00m
Bed - length - 1.95m
Bed - width as double - 1.57m
Bed - width as single - 0.53m
Door - width - 0.60m
Door - height - 1.58m

 

 

Dimensions: Pre-2018 Models with 750Kg max load.

External Dimensions:

Length - 4.20m including 0.99m hitch & bar.
Width - 1.85m
Height - 2.05m roof down. Raising pop top adds 30cm.
*Note regarding garage storage  Recommended minimum clearance - 210cm.
MiRO - Varies with model & each unit's spec.
Brakes - AL-KO Braking System.
MTPLM - 750Kg
Nose Weight - 49Kg (54Kg with front box & gas bottle plumbed) 
Ground Clearance. - 183mm NB: Lowest point is the removable spare wheel.
     

Internal Dimensions:

Standing height - 1.84m
Floor - full length - 2.05m
Floor - width - 0.62m
Floor - bed end of aisle to door   - 1.00m
Bed - length - 1.95m
Bed - width as double - 1.57m
Bed - width as single - 0.53m
Door - width - 0.60m
Door - height - 1.58m

Notes:

More information and specs on current models can be found on each model's page at: www.2berthcaravan.co.uk

Measurements and weights shown are intended as a guide and may vary, be approximated or estimated where necessary.

Due to the manufacturing process, each Go-Pod may have some variation in it's dimensions and therefore the sizes & weights shown are approximated. This is due to variation between moulds and the thickness of the GRP applied.

We therefore recommend that adequate tolerance is allowed if your storage area is limited.

These measurements superceed all previously published specs.

Add a comment:

Leave a comment:

Comments

Add a comment